TC-Helicon VoiceTone Synth Manual - Manual (Page 17)

17 17 17
Back Panel
the preamplified Mic Input signal if needed for external
mixing.
4. Instrument In and Thru Connections
Connect an instrument here to provide the vocoder
carrier signal (“Inst” input only). A chordal instrument
connected here such as a guitar can also set key and
scale for the HardTune and Vocoder’s Synth and Robot
effects.This input is high impedance to accept single coil
guitar pickups. Plug a 1/4” cable from the Thru jack to
your first effect pedal or to your amplifier/PA.
5. Guitar Ground Lift
Push in to overcome buzzing that may occur when the
Thru jack connects to a different amplifier/PA than the
Mono Out. Leave out when Thru is not connected.
6.
Mic Input
Connect your mic here. When Vocoder is on, this input
is the modulator.
1
2 3 4 5 6
1. USB connector
Connects Synth to your computer for backup, restore
and editing of presets (install VoiceSupport from CD).
2. Power Input
Connecting the power adaptor turns the unit on.
3. Outputs
The output of Synth is mono only. Connect this to a mic
or line input of your PA system.The Dry output passes