Citizen Systems Citizen PPU PPU-700 - Manual (Page 9)

— 6 —
Please observe the following precautions for power source and power
cord:
● Use the printer only at the specified supply voltage and frequency.
● Use only the specified AC adapter with the printer.
● Check to make sure that the supply outlet from which the printer is
powered has a sufficient capacity.
● Do not supply the printer from a power strip or current tap shared
with other appliances.
● Do not plug the power cord into a supply outlet with dust or debris
left on its plug.
• Neglecting to handle properly may result in printer failure, emission
of smoke, fire, or electric shock.
• An overload may cause the power cord to overheat or fire or the
circuit breaker to trip.
● Do not leave things around the supply outlet.
● Use the printer near a convenient wall outlet, readily accessible in an
emergency.
• Otherwise the printer may not be immediately shut down in an
emergency.
● Insert the power plug fully into the supply outlet.
● If the printer is likely to be out of use for a long time, leave it
disconnected from its supply outlet.
Plug or unplug the power cord or other cables with the power off and
by holding the plug or connector.
Do not use the power cord or other signal cables under the following
conditions.
● A state where the power cord or cable is loaded by something or
trampled on.
● A state where the printer is used or carried with its power cord bent,
twisted, or pulled
● Do not lay the power cord in the neighbor of a heating device.
● Do not attempt to modify the power cord unnecessarily.
• Neglecting these cautions may cause wires or insulation to break,
which could result in leakage, electric shock, or printer failure. If a
power cord sustains damage contact your CBM dealer.
Be sure to firmly insert the cable plug into its mating socket.
• A cross connection may damage the printer’s internal electronics or
the host system’s hardware.
CAUTION