StarTech.com PDU02IPSC Manual - Manual (Page 13)

Instruction Manual
9
UPS Status (PDU02IPSC Only)
The UPS Status information will display to the left of the power switches on the
Monitor Tab. If you have connected an APC Smart UPS series device to the RS232 port
on the PDU02IPSC, you can monitor the following information about your UPS.
Alive - Displays the state of the UPS device as either Normal (1) or Offline (0).
Model - Displays the connected UPS model.
AC Fault - Displays if there is an AC fault causing the equipment to function on UPS
battery power – Normal (0), AC Fault (1)
Output Overload - Displays either Normal (0) or Overload (1) state - Overload is
shown if the power draw exceeds the output limit set by the UPS when operating on
battery power.
Battery Level(%) - Displays the remaining battery capacity as a percent value.
Battery Run Time (Min) - Displays the remaining battery capacity in minutes.
Battery Low - Displays either Normal (0) or Low (1) state – the Low state threshold is
set by the UPS.
Replace Battery - Displays either Normal (0) or Needs Replacement (1) - the Needs
Replacement state threshold is set by the UPS.