StarTech.com SV431USBAN - Manual (Page 19)

Instruction Manual
15
Hotkey Beeper Control
The Beeper can be hotkey toggled On and Off. To toggle the Beeper, do the following:
1. Invoke HSM (see “Invoking Hotkey Setting Mode”).
2. Press and release the [B] key.
The Beeper toggles On or Off. The Command Line displays Beeper On or Beeper Off for
one second, then the message disappears and you automatically exit Hotkey Mode.
Disable Port Switching Keys
To disable the Port Switching Keys ( [Scroll Lock], [Scroll Lock] / [Ctrl], [Ctrl] ), do the
following:
1. Invoke HSM (see “Invoking Hotkey Setting Mode”).
2. Press [X] [Enter].
Restore Default Settings
To reset the KVM Switch to its default hotkey settings, do the following:
1. Invoke HSM (see “Invoking Hotkey Setting Mode”).
2. Press [R], [Enter].
Invoke Firmware Upgrade Mode
To set the KVM Switch to Firmware Upgrade Mode, do the following:
1. Invoke HSM (see “Invoking Hotkey Setting Mode”).
2. Key in: upgrade.
3. Press [Enter].
The front panel port LEDs flash to indicate Firmware Upgrade Mode is in effect.
Please Note: To exit Firmware Upgrade Mode, you must power off the switch.