beautypg.com

Installation, Preparing your site – StarTech.com ST128UTPE User Manual

Page 5

background image

Instruction Manual

2

Installation

The VGA Extender is composed of two different units: the ST124UTPE(4- port)/

ST128UTPE(8-port) Extender and Splitter, along with a STUTPRXL Remote Receiver

(available seperately). The VGA Extender takes the output from a VGA source (usually a

computer) and transmits it to one or more Remote Receivers over Category 5 Ethernet

cable. Each remote display (monitor, projector) connects to a Remote Receiver using

a standard VGA connection and displays the image from the local computer on the

remote display.

Preparing Your Site

Before you can install the VGA Extender, you need to prepare your site.
1. Determine where the local computer will be located and set up the computer.
2. Determine where the remote displays will be located, situate them appropriately.
3. If you are using surface cabling, ensure you have enough Category 5 Ethernet

cabling to connect the VGA Extender to each remote location, and that each end is

terminated with an RJ-45 connector.

OR
If you are using premises cabling, ensure that the Category 5 Ethernet Cabling

between the VGA Extender and each remote display location has been properly

terminated in a wall outlet in each location and there is a patch cable long enough to

connect the Remote Receiver and the VGA Extender to their respective outlets.

This manual is related to the following products: