Source Audio Soundblox 2 Stingray Multi-Filter - Manual (Page 7)

External Control 22 |
5. Set the desired high position of the knob.
6. Press the CONTROL INPUT button to complete the assignment. The LED
will blink three times to indicate the process is complete.
Note: This control assignment can be programmed to a preset. Don’t forget
to save your settings! Also, each external controller can only be assigned to
one parameter. To restore an external controller to modulation, see below.
Restoring control assign mode to modulation
In the event that you have saved a preset with external control assigned to
one of the parameter knobs, but wish to return to the default external
modulation control, follow the instructions below:
1. Engage the desired preset.
2. Deselect all the external control options with the CONTROL INPUT button
(no CONTROL INPUT LEDs should be illuminated).
3. Press and hold the CONTROL INPUT button until all three LEDs blink two
times, then release.
4. Select the desired external control option (HH, MIDI, or EXP).
5. Save the preset. The external controller will now control the effect’s
modulation.
Controls: Knobs | 7
CONTROLS: KNOBS
EFFECT (A) (not labeled)
The EFFECT knob selects which effect type will be used. For information
on the individual settings, see the Effect Types section.
A
1 2
CONTROL
INPUT
OPTION
SELECT
ENV- ENV+
DEPTH
OPTION
SPEED
DELAY/FREQ
FEEDBACK
VOLUME
TREMOLO
MIX
(HOLD)
DEFAULT
HH
MIDI
EXP
FLANGER
CHORUS
PHASER
RESONATOR
MOD SOURCE
4 STAGE
QUAD
CLASSIC
THRU
ZERO
SHADOW
RES 1
RES 2
VIBE
6 STAGE
8 STAGE DUAL
12 STAGE
O RB I TAL
MODU L A T OR
Stingray Manual - pages 22, 7