Sonics 4096 Actuator - Manual (Page 20)

I N S T R U C T I O N M A N U A L • M O D E L 4 0 9 5 / 4 0 9 6
19
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
STROKE SPEED ADJUSTMENT
The velocity at which the horn descends and returns can be adjusted via the
speed controls. These controls are factory adjusted for average operating
conditions and should not require further adjustment. However, if a minor
adjustment is necessary, adjust in small degrees. Turn clockwise to slow the
extend speed, and counterclockwise to increase the return speed.
The speed controls are 2 small threaded screws located at the top of the
press and behind the air cylinder as shown below.
The top screw controls the extend speed – turn it clockwise to slow the
speed, counterclockwise to increase the speed. The bottom screw controls
the return speed – turn it clockwise to slow the speed, counterclockwise to
increase speed.
Excessive velocity may
be unnecessary and
harmful to the system.
EXTEND
SPEED
CONTROL
RETURN SPEED
CONTROL
Go To Top Of Document