Sonics 4096 Actuator - Manual (Page 12)

I N S T R U C T I O N M A N U A L • M O D E L 4 0 9 5 / 4 0 9 6
11
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
I N I T I A L E Q U I P M E N T S E T U P
ASSEMBLING AND MOUNTING CONVERTER, BOOSTER,
AND HORN
If the converter, booster, and horn are not already assembled, follow these
instructions:
1. Clean the mating surfaces of the converter and booster, as well as the
threaded stud and hole. Check that the stud is tight (see recommended
torque requirements on page 12).
2. Hand assemble the converter and booster together. Using open-ended
wrenches as shown below, tighten until snug. Then, using a torque wrench,
tighten to 25-35 foot-lbs.(34-47 newton-meters). Do not force or
overtighten.
3. Clean the mating surfaces of the booster and horn, as well as the threaded
stud and hole. Check that the stud is tight. (See recommended torque
requirements on next page.)
4. Hand assemble the horn to the booster. Using open-ended wrenches as
shown below, tighten securely. Then, using a torque wrench, tighten to 25-
35 foot-lbs. (34-47 newton-meters). Do not overtighten.
CONVERTER/BOOSTER
BOOSTER/HORN
Never tighten the horn to
the booster using the
housing door as the upper
wrench as this may cause
damage to the booster
and/or converter.
Go To Top Of Document