Sonics VCF1500HV - Manual (Page 15)

6. If the Ultrasonic Processor stops working due to an overload condition set the
POWER switch to OFF, investigate and remedy the problem, then set the
POWER switch back to ON. Reset the instrument by depressing the TEST
switch.
RETURN OF EQUIPMENT
It is suggested that an Ultrasonic Processor in need of repair be sent back to the factory.
In order to receive prompt service; always contact the factory before returning any
instrument. Include date of purchase, model number and serial number. For instruments
not covered by the warranty, a purchase order should be forwarded to avoid unnecessary
delay. Care should be exercised to provide adequate packing to insure against possible
damage in shipment. The Ultrasonic Processor should be sent to the “Service
Department” with all transportation charges prepaid and return of shipment indicated.
Please obtain a Return Authorization Number prior to returning the instrument.
IMPORTANT
I CERTIFY THAT THE ULTRASONIC PROCESSOR AND / OR ACCESSORIES RETURNED
FOR REPAIR ARE FREE OF ANY BIOHAZARDOUS OR RADIOACTIVE MATERIAL AND A
SAFE FOR HANDLING.
RE
DO NOT RETURN ANY EQUIPMENT UNLESS SUCH CERTICATION CAN BE MADE.
15
Go To Top Of Document
Go To Top Of Document