Solvline ZCS-232 - Manual (Page 14)

ZCS-232 User Guide
14
When the mode is successfully changed from setup mode to active mode, any additional operation may
display the message shown above. When it is set to active and configuration is complete, click “Delete
Device” to remove the device from the list. If you need to apply an additional changes, please refer to
changing active mode to setup mode explained previously.
F. Refresh
To refresh the ZCS-232 information in the list or to check whether the device is connected with the setup
mode, click “Refresh” button. When refresh is completed, following message will appear.
G. Reboot
To restart the firmware in ZCS-232, click the “Reset” button. Usually when changing from SETUP mode
to에 ACTIVE mode, this feature is used.