Figure 3a. activating the tamper-resist feature – SilentKnight B224RB 6 Mounting Base w/Built-in Relay User Manual
Page 4

D250-03-00
4
I56-2815-000R
©2005 System Sensor
Three-Year Limited Warranty
System Sensor warrants its enclosed smoke detector base to be free from defects in
materials and workmanship under normal use and service for a period of three years
from date of manufacture. System Sensor makes no other express warranty for this
smoke detector base. No agent, representative, dealer, or employee of the Company
has the authority to increase or alter the obligations or limitations of this Warranty.
The Company’s obligation of this Warranty shall be limited to the replacement of
any part of the smoke detector base which is found to be defective in materials or
workmanship under normal use and service during the three year period commenc-
ing with the date of manufacture. After phoning System Sensor’s toll free number
800-SENSOR2 (736-7672) for a Return Authorization number, send defective units
postage prepaid to: System Sensor, Returns Department, RA #__________, 3825 Ohio
Avenue, St. Charles, IL 60174. Please include a note describing the malfunction and
suspected cause of failure. The Company shall not be obligated to replace units
which are found to be defective because of damage, unreasonable use, modifica-
tions, or alterations occurring after the date of manufacture. In no case shall the
Company be liable for any consequential or incidental damages for breach of this or
any other Warranty, expressed or implied whatsoever, even if the loss or damage is
caused by the Company’s negligence or fault. Some states do not allow the exclu-
sion or limitation of incidental or consequential damages, so the above limitation or
exclusion may not apply to you. This Warranty gives you specific legal rights, and
you may also have other rights which vary from state to state.
PLASTIC LEVER
BREAK TAB AT
DOTTED LINE BY
TWISTING TOWARD
CENTER OF BASE.
USE SMALL-BLADED
SCREWDRIVER TO
PUSH PLASTIC LEVER
IN DIRECTION OF
ARROW.
Figure 3A. Activating the tamper-resist feature:
C0144-00
Figure 3B. Removing the detector head from the base:
Please refer to insert for the Limitations of Fire Alarm Systems