Assembly – SIG SAUER ACP Adaptive Carbine Platform User Manual

Page 3

www.sigsauer.com

ASSEMbLY

WARNiNG: be sure your pistol is unloaded, with magazine removed, and
pistol action locked open, before proceeding.

Remove the Rear Locking Assembly by depressing
on the Rear Locking Plate detent pin located on
the top of the ACP while sliding the Rear Locking
Assembly off the back.

Remove the Polymer Adapter Clamp from the
front of the ACP by pulling down on the adapter
clamp retaining pin and pushing rearward on the
Adapter Clamp through the front of the ACP, just
below the barrel opening.

Slide the Front Polymer Adapter Clamp onto the
accessory rail of the pistol.

The Adapter Clamp Assembly should be seated
as close to the front of the trigger guard as
possible while still maintaining a positive lock
with the rail stop. Make sure the holes in the
Polymer Adapter Clamp line up with the rail slots
on the pistol. Insert the “L” shaped Adapter Rail
Lock to guarantee placement. Adapter Rail Lock
should only be inserted from the right side.

Hold the ACP by the top rail and insert the
pistol and Adapter Clamp Assembly into the
corresponding rails located inside the front of
the ACP.

Push the pistol as far forward as possible and
slide the Adapter Clamp Assembly retaining pin
back into the adapter.