SIG SAUER Universal Sight Pusher - Manual

The SIGARMS TM Sight Adjustment Tool is used to adjust, remove and install front
and rear sights on SIG Sauer TM Pistols. There are two variants - one for Classic
Pistols (P220, P225, P226, P228, P229, P239, P245) and one for sigpro TM Pistols
(SP2340, SP2009). This card includes separate instructions for front & rear
sights, as well as general information to assist you in sighting your pistol.
UNLOAD THE PISTOL BEFORE STARTING! UNLOAD THE PISTOL BEFORE STARTING!
General Information
1. You can adjust the position of the T-Handle by loosening the T-Handle
Adjustment Hex Screw (use a 1/8” hex key) - do not overtighten.
2. Sights may be removed from either side of the slide. Sights should ALWAYS
be installed from the left side of the slide, as viewed by the shooter when firing.
3. When installing, the sight base must be aligned and seated in the dovetail of
the slide before making adjustments with the Sight Adjustment Tool. Tapping the
opposite side of the sight base with a plastic hammer or end of a plastic screw
driver will help seat the sight in the dovetail.
4. A drop of gun oil in the dovetail slot prior to starting will ease installation.
5. Not all after-market sights may be manufactured to the correct dovetail
dimensions - to ensure the right fit use only genuine SIG Sauer
TM sights -
available in contrast, three-dot, and SIGLITE TM night sights.
SIGARMS SIGARMS TM TM SIGHT ADJUSTMENT TOOL SIGHT ADJUSTMENT TOOL
O O perating perating I I nstructions nstructions
Universal Sight Pusher 2002.qxd 9/25/2002 1:42 PM Page 1