SeaLand 712-TM09 Toilet - Manual (Page 4)

4
Your SeaLand 72-TM09 toilet is designed for years of
dependable trouble-free service. However, during the life
of the product, certain parts may require replacement.
The following is a list of parts kits which may be required
for maintenance purposes.
MoDeL IDeNTIfICATIoN
The model identification label is located on the toilet base
under the pedestal cover.
ToILeT opeRATING INSTRuCTIoNS
To properly use the SeaLand toilet, follow these simple
instructions:
. Use biodegradable tissue such as SeaLand
® brand.
2. To add water to the toilet before using, lift or raise
the flush pedal.
3. To flush toilet, push pedal all the way down until
sewage leaves the toilet bowl. Water flow pressures
vary at different locations and therefore, holding the
flush lever down 4-8 seconds may be required. A flow
of 2-4 GPM (8-5 Lpm) is recommended for proper
rim and bowl wash.
4. Allow flush pedal to snap back, which permits positive
sealing around the flush ball.
5. A small amount of water should remain in the bowl.
Note: Holding the flush pedal down longer than neces-
sary results in excessive water usage.
CAuTIoN: Do not dispose of sanitary napkins or other
non-dissolving items in the toilet.
ToILeT MAINTeNANCe
CLeANING
The SeaLand toilet should be cleaned regularly for
maximum sanitation and operational efficiency.
Clean the toilet bowl with a mild bathroom cleaner,
such as SeaLand ® Toilet Bowl Cleaner. Do not use
chlorine or alcohol-based caustic chemicals such as
drain opening types, as they will damage the seals.
If an odor is apparent from the toilet:
1. Clean out system by flushing several gallons of fresh
water through with one cup of liquid laundry soap.
2. Add odor control deodorant in amount specified for
your holding tank capacity after cleaning and every
few days during use.
pRepARING foR SuMMeR uSe
To prepare the SeaLand toilet for summer use, turn on
water supply and check system for leaks. Flush toilet,
check for leaks and repair as necessary. Your SeaLand
toilet is now ready for use.
DOMETIC CORPORATION
P.O. BOX 38, 13128 STATE RT 226 (800) 321-9886
BIG PRAIRIE, OH 44611 USA
MODEL NO.
000
SERIAL NUMBER
000000
SpARe pARTS
part Number Description
3853862 Ball, Shaft & Cartridge Kit
38530677 Seal Kit
38534349 Water Valve Kit
38536906 Vacuum Breaker Kit
WINTeRIzING
At the end of each season, the SeaLand toilet should be
winterized for storage by either draining or using potable
water-safe antifreeze in the system.
To drain:
1. Thoroughly flush system with fresh water.
2. Empty holding tank.
3. Shut off water supply to toilet. Disconnect water line.
4. Press pedal until all water is drained from toilet.
To use antifreeze:
1. Thoroughly flush system with fresh water.
2. Empty holding tank.
3. Drain potable water tank.
4. Add freshwater antifreeze and water mixture
through toilet and into the waste holding tank. Each
installation is different, so amounts may vary. User
discretion is required to assure adequate protection.
5. Empty holding tank.
Note: Use nontoxic antifreeze designated for potable
water systems.
CAuTIoN: Never use automotive-type antifreeze in
freshwater systems.
Tank Level Indicator:
2. Lubricate inside surface of rubber sealing grommet
and outside surface of probe body with liquid dish-
washing detergent. Insert level indicator into rubber
sealing grommet.
INSTALLATIoN INSTRuCTIoNS (cont’d)