SeaLand 712-TM09 Toilet - Manual (Page 3)

3
Toilet Installation:
4. Remove plastic pedestal cover from toilet base.
5. Install the (4) /4-20 x -3/4" long studs in inserts on
the tank top.
6. Place floor flange seal on studs, aligning the studs
with bumps on seat. Note: “THIS SIDE UP” should
face upwards.
7. Place toilet on studs and secure with four washers
and four nuts. There should be no gap between the
bottom of the toilet base and the top of the tank.
Water line:
8. Locate water valve at rear of flush lever.
9. Attach water supply line from water system to inlet
fitting on back of water valve.
flush pedal cover:
0. Place outer pedal cover over metal lever. Push pedal
down, and secure inner pedal cover to outer cover with
supplied fasteners.
pedestal cover:
. Slide back side of pedestal cover around rear of
toilet base and snap in groove. Close front half of
pedestal cover and snap in groove.
INSTALLATIoN INSTRuCTIoNS (cont’d)