SeaLand 4800 Series VacuFlush - Manual (Page 7)

7
SeaLand 4800 Series VacuFlush Toilet Specifications
5.4 Dimensions (fig . 4 , page 2)
Ref. Dimension
A 18 .125 in . / 460 mm
B 14 .75 in . / 375 mm
C 18 .625 in . / 473 mm
D 17 in . / 432 mm - seat height
E 15 .75 in . / 400 mm
F 33 .5 in . / 851 mm - seat lid up
Ref. Dimension
A 14 .75 in . / 375 mm
B 14 .75 in . / 375 mm
C 18 .25 in . / 464 mm
D 13 .625 in . / 346 mm - seat height
E 14 .875 in . / 378 mm
F 30 .25 in . / 768 mm - seat lid up
Models 4809, 4848, 4829 Model 4806, 4826
6 Operation
6.1 Toilet system start-up
1 . Fill freshwater tank .
2 . Turn on electrical power and water supply to toilet .
3 . Flush water through entire toilet system by flushing toilet five times (press Flush switch and allow
each flush cycle to complete until green light indicates system is ready for next flush) . Each cycle
takes about one minute .
6.2 Normal toilet operation
ADD WATER TO TOILET BOWL
Press “Add Water” switch until desired water level is achieved . More water is usually
added only when flushing solids . (If switch is pressed too long, water flow will shut off
automatically to avoid overflow .)
FLUSH TOILET
Press “Flush” switch down for a moment, then release it . Flush only when the green
“OK to Flush” light is on . Toilet will not flush until the green “OK to Flush” light is on .
It takes about one minute for vacuum to recharge for the next flush .
If the red “Do Not Flush” light is on, the system is either recharging the vacuum, or the
holding tank is full . Do not attempt to flush the toilet during these conditions, or a clog
may occur in the toilet system .
DO NOT FLUSH FOREIGN OBJECTS
CAUTION! Flush only water, bodily wastes and rapid-dissolving tissue paper . Do not
flush wet wipes, sanitary napkins, condoms, diapers, razor blades paper cups, cotton
swabs food, hair or liquids such as oils or solvents . Clogging or damage to the toilet
system may occur .
Note
Make sure all guests understand toilet operation before use.