Quick setup guide, Connect balance to electrical outlet, Level balance – Scientech 12000 Series User Manual
Page 28: Unlock clamping screw, Place in proper environment, Unpack balance, Warm up 1 hr, then calibrate, Turn on balance
28
Quick Setup Guide:
Adjust the FRONT FEET to level the balance by centering the
LEVEL INDICATOR.
5
CONNECT BALANCE
TO ELECTRICAL OUTLET
3
LEVEL BALANCE
4
UNLOCK CLAMPING SCREW
1. Remove the paper tag.
2. Turn the knob, in the direction shown until finger tight.
See page 4 of the manual.
2
PLACE IN PROPER
ENVIRONMENT
1
UNPACK BALANCE
but does not rotate.
The shaft moves in and out
against bottom of case.
in the same position
turns but stays
Thumbwheel
Calibration instructions in manual.
7
WARM UP 1 HR, THEN
CALIBRATE
Press the ON/OFF switch and make sure the balance
goes through the following sequence.
6
TURN ON BALANCE
Rotating thumbwheel('s) as
RAISES front of balance.
extend out of case and
shown causes Shaft to