Scientech 12000 Series - Manual (Page 17)

17
Command Response Purpose
[decimal number]_PCT[CR] None Puts the balance on the percent weighing mode with the
displayed reading converted to the percent entered. The
display must be non-zero when this command is issued. If
the display is zero, a 3 second "Err" message is displayed
and the balance returns to its normal weighing mode.
CLEAR exits the percent mode and un-defines the percent
register.
[Decimal number]_ENTER_[integer]
_PIECES[CR] None Accepts the decimal number as a weight in "last front panel
units" per integer pieces. If the balance is not in PCS mode,
it goes into PCS mode using the decimal number/the integer
as the weight. If used when the balance is already in PCS
mode, the display digits are blanked for about 1 second
while the PCS and "last front panel units" annunciators are
lit. The balance then resumes normal PCS operation using
the decimal number/the integer as the unit weight.
[register
number]_RCL_[(CONVERT) (CAL)
(PIECES)][CR] REG XXX :[register
contents][MULT.] Puts the recalled register contents into the specified mode
register and enters that mode.
TAVG[CR] None Clears the TBAR registers and enters the TBAR mode.
RESET_TAVG[CR] None Clears the TBAR registers. If the balance is in the TBAR
mode, the process keeps running.
XAVG[CR] None Accumulates the current weight in the XBAR registers.
RESET_XAVG[CR] None Clears the XBAR registers.
GLP[CR] Sends GLP header Puts balance in the GLP mode.
XAVG[CR] Sends weight while in GLP Accumulates the current weight in the XBAR registers.
RCL_XAVG[CR] Sends statistics and signature
line Terminates GLP mode.
ISO[CR] Sends ISO header and waits
for target weight entry Puts balance in ISO mode.
xxx.xx_Targ[CR] Sends target weight (g) Enter target weight value in grams.
SEND[CR] Sends weight, difference
between weight and target,
and signature line Terminates ISO mode.
ASON[CR] or ASOFF[CR] See the RS-232 Balance
Message Formats section. Turns auto send on or off. When auto send is on, a time
interval must be entered into register 89 (see Type 4
commands).
CSON[CR] or CSOFF[CR] See the RS-232 Balance
Message Formats section. Turns continuous send on or off.
ACAL[CR] None Starts the automatic internal calibration weight calibration
routine.
Type 2 Commands – Balance Input Functions:
Command Response Purpose
[register number]_STORE[CR] None Stores the current weight, at the greatest possible resolution, in the
specified register.
[Decimal number]_ENTER_[register
number]_STORE[CR] None Stores the number entered, in the current units, as an additive
constant in the register specified.
[decimal number]_ENTER_CONVERT_[register
number]_STORE[CR] None Stores the number entered, as a "last front panel units" relative
multiplier, in the specified register.
[decimal number]_TARE[CR] None Adds the number entered, in current units, to the TARE register.
CLEAR [CR] zeroes the TARE register.
[decimal number]_ENTER_86_STORE[CR] None
Stores the desired precision of the displayed weight for T mode.