Scientech 12000 Series - Manual (Page 18)

18
Type 3 Commands – Balance Output Functions:
Command Response Purpose
SEND[CR] See the RS-232 Balance Message Formats section. Returns the contents of the display register.
[register number]_RCL[CR] REG XXX:[register contents][current units or
'MULT.'] [CR] [LF]
Sends the contents of the specified register
in the current units if it is additive or with
the designator 'MULT.' if it is multiplicative.
An unflagged number is sent with no
designator. An undefined register returns a ?
with a [CR][LF].
RCL_TARE[CR] REG 091:[TARE register contents] [current
units][CR][LR] Return the TARE register's contents.
RCL_[(CONVERT)(CAL)] REG XXX:[contents of specified
register][MULT.][CR][LF]
Returns indicated register contents, if in that
mode. If not in that mode then a ? with a
[CR][LF] is returned.
RCL_PCS[CR] REG XXX:[contents of pieces register][last FP
units/pc][CR][LF] Returns pieces register contents expressed as
last front panel units/pc, if in that mode. If
not in that mode then a ? with a [CR][LF] is
returned.
[register
number]_RCL_TARE[CR] REG XXX:[register contents][current units][CR][LF] Adds the specified register contents to the
TARE register.
RCL_XAVG[CR] [average weight] [current units] AVX[CR][LF]. [2
second delay]. [number of samples taken]
###[CR][LF]. [2 second delay]. [standard deviation]
[ current units] SDEV[CR][LF]. [2 second delay].
[relative standard deviation] COV[CR][LF]. Sends the results of a standard deviation run.
The TBAR mode, if in use, is temporarily
suspended while this process is going on.
Type 4 Commands – Clock/Calendar Functions:
Command Response Purpose
[six digit integer]
_ENTER_100_STORE[CR] Sets the calendar function, if available, to the specified
date. The date must be specified in the MMDDYY
format and no delimiters.
100_RCL[CR] REG 100: MM.DD.YY DATE[CR][LF] Returns the date.
[six digit integer]
_ENTER_101_STORE[CR] Sets the clock function, if available, to the specified
time. The time must be specified in the HHMMSS
format using military 24 hour time format.
101_RCL[CR] REG 101: [HH:MM:SS]
TIME[CR][LF] Returns the current time, using military 24 hour time
format, once for each request.
[1 to 6 digit integer]
_ENTER_89_STORE[CR] Sets the auto send register to the specified send time
interval. For the auto send feature to be operational,
you must set the auto send selection to ON (see RS-
232 Front Panel Configuration section for details).
The format used is HHMMSS with no delimiters. For
instance, to set the auto send interval to 5 minutes and
25 seconds, you would send this command string: 525
ENTER 89 STORE[CR]. Also you must have the auto
Send selection set to ON before the auto Send will
work (see RS-232 Front Panel Configuration Section).
89_RCL[CR] REG 089: [HH:MM:SS]
INTV[CR][LF] Returns the auto SEND time interval currently set.
[(1)(0)]_ENTER_79_STORE[CR] A 1 in register 79 disables the date/time stamp feature
of any SEND. A 0 in register 79 enables the date/time
stamp.