Sceptre X220T-Naga - Manual (Page 16)

Page16 SCEPTRE X22
If You Have VGA Connection on Your Video Card…
1. Make sure the power of X22 LCD MONITOR is turned off.
2. If you were previously using a CRT (bulky) monitor, please hook up your old
monitor first and make sure your refresh rate is set to 60 Hz frequency before using the
X22 LCD MONITOR. You can find the refresh rate information and change it by RIGHT
CLICKING on the desktop with nothing selected. After you have right clicked, select the
PROPERTIES option. Click on the SETTINGS tab. Click on the ADVANCED button.
Click on the MONITOR tab. In that tab, change the refresh rate to 60Hz and click on
APPLY. After the refresh rate changed, please shut down the computer and monitor.
3. Obtain the VGA cable and connect to the VGA connection on your PC. Connect the
other end of the cable to your X22 LCD MONITOR.
4. Obtain the audio cable and connect the 3.5 mm Mini-jack cable to the Audio Line In
connection of the monitor. Connect the other end of the 3.5 mm Mini-jack cable to your
PC’s audio line out connection.
5. Turn on the power of both the X22 LCD MONITOR and the PC.
Please Note :
•
The PC’s clearest picture is produced under 1680x1050 at 60Hz.