Reznor JT4BD Option - Installation - Snow Stand - Manual (Page 4)

INSTALLER: PLEASE LEAVE THESE INSTALLATION
INSTRUCTIONS WITH THE HOMEOWNER.
5. Slide the opposite end tabs of the Center Brace into
the opposite Legs. Drive two screws into the top
the Center Brace and through the holes in the top
flange of the legs.
6. Position the fourth Leg into place, making sure the
tabs of the Leg have slid into the slots in the Side
Braces. Once in place, drive four screws into their
respective side holes of the Leg.
UNIT INSTALLATION
1. Locate the Snowbase where the final installation of
the condensing unit will be. Orient the Snowbase
so that the valve corner of the condensing unit,
when installed, will not sit on the Center Brace.
2. Lift the condensing unit to a level height above the
Snowbase.
3. Position the condensing unit over the Snowbase.
Lower the unit so that the tabs on the top of the
Snowbase fit into the grooves on the underside of
the composite base pan on the condensing unit. It
will be fully installed when the unit will not rotate
more than five degrees.
Underside of
Basepan
Tab
709062B (Replaces 709062A)
Specifications & illustrations subject to change
without notice or incurring obligations (02/14).