Reznor DF6SF Option - Installation - Skirt Trim Kit - Light Commercial - Manual (Page 3)

3
2. Install the fi rst long rail cover by hooking the offset
fl anges of the rail cover into the fork truck openings
of the base rail. (See Figure 2a below) Then rotate
the rail cover up against the base pan wherein the
upper edge of the rail cover is above the base rail
and below the side sheet metal. (See Figure 2b
below) Then where you had removed the #10 x ½”
screws in step 1 use the #10 x 1 ¼” to loosely secure
the rail cover to the unit base. – DO NOT TIGHTEN
SCREWS.
3. Install the fi rst short rail cover by hooking the offset
fl anges of the rail cover into the fork truck openings
of the base rail, as above, except holding it to the
right and against the base pan wherein the upper
edge of the rail cover is above the base rail and
below the side sheet metal. (See Figure 3a below)
slide the rail cover to the left wherein the left edge
of the rail cover is under the right side fl ange of the
previously attached rail cover. (See Figure 3b below)
Then where you had removed the #10 x ½” screws
in Step 1 use the #10 x 1 ¼” sheet metal screws to
loosely secure the rail cover to the unit base. – DO
NOT TIGHTEN SCREWS.
Hook the Offset Flanges
of the Rail Cover over
the fork Truck Openings
Figure 2a
Figure 2b
Start the #10 x 1 1/4”
Long Sheet Metal
Screws - Do Not Tighten
Figure 3a
Figure 3b