Reznor DF6SF Option - Installation - Skirt Trim Kit - Light Commercial - Manual (Page 2)

2
INSTALLATION
1. Remove only the three (3) sheet metal screws from
the long base rails and only the two (2) sheet metal
screws from the short base rails on each side which
corresponds to the slotted holes in the rail covers.
(See Figure 1a and Figure 1b below) Note the base
rails will remain attached to the base pan with the
screws you have not removed. DO NOT DISCARD
THE SCREWS REMOVED. You will reuse eight (8)
of these screws later in the corner fl anges of the rail
covers, see Step 6 below.
Figure 1b
NOTE: If the underside shipping boards and brackets
have not been removed from the unit they should be
removed before proceeding. Do not discard the shipping
boards and brackets if there is a chance that the Unit will
have to be handled with a fork truck in the future.
Figure 1a
Remove Screw
Remove Screw
Remove Screw Remove Screw
Remove Screw
Remove Screw
Remove Screw
Remove Screw
Remove Screw
Remove Screw