Reznor R6GN Option - Installation - Horizontal Roof Curb (559542) - Manual (Page 2)

INSTALLATION INSTRUCTIONS
MODEL 559542
HORIZONTAL ROOF CURB USED WITH R6GN 150/180 UNITS
INSTALLATION
INSTRUCTIONS
HINGE
De tail "B" De tail "A"
HINGE PIN
TAPERED END
CURB SIDE
Fig ure 3
Step 3:
Corner Assembly: Align each curb side as shown in Detail "A". Using a hammer, drive the curb "hinge" pin down until the
top of the pin is below the top of the curb as shown in Detail "B".
Step 4:
After the four corners are assembled; the curb should be checked to be sure it is in "square". Do this by measuring
diagonally from each opposite corner. The two measurements should be the same for each direction. See Figure 3.