Reznor RDF Option - Installation - Weather Hood Assembly - Manual (Page 3)

Form RZ-NA-I-RDF-WH, Mfg P/N 131135, Page 3
On the air inlet opening side of the system cabinet, remove the
sheetmetal screws from the bottom rear inset and the screws across
the top edge.
Align the edges of the inlet hood cabinet section with the grooves in
the system cabinet. Slide top edge of the inlet hood cabinet section
underneath the edge of the system cabinet top.
Rotate the assembly so that it fits into the recess across the bottom
of the cabinet opening. Attach by replacing the two corner screws
and one center screw across the top, the three screws across the
bottom, and one halfway up on each side as illustrated. Adjust the
support legs to the appropriate height and tighten bolts securely.
2. Assemble and Install Support Legs
P/N 91581,
Support Leg Half
P/N 91581,
Support Leg Half
Step 2A - Sub-assemble Support Legs
Attach sub-assembled
legs at pre-drilled holes.
Attach sub-assembled
legs at pre-drilled holes.
Attach sub-assembled
legs at pre-drilled holes.
Step 2B - Install
Support Legs
Parts Required - Three
sub-assembled legs and
three 3/4" sheetmetal
screws
Attach leg assemblies to
cabinet bottom.
3. Attach Assembled Cabinet Section
System Cabinet Top Cabinet Section
of Inlet Hood
Remove scr
ews and
slide edge of cabinet
underneath top.
Step 1E - Attach Cabinet Section Bottom
Parts Required - Subassembly from Step 1D; cabinet section bot-
tom; and six 1/2" sheetmetal screws.
Position the cabinet section bottom to the inside of the four posts
(corners). Attach as illustrated.
P/N 91567
Bottom of Hood
Cabinet Section
Parts Required - Six sup-
port leg halves and six
5/8" bolts and nuts
Assemble support legs as
illustrated. Adjust legs to
shortest length and
tighten bolts finger tight.
Length of supports will
be re-adjusted to suit the
application after cabinet
is installed.
4. Assemble Air Inlet Hood Section with Louvers
P/N 91569,
Right Side
of Hood
P/N 91568, Left Side of Hood
Step 4A - Attach Hood Sides
Parts Required - Right and left triangular shaped sides and 18
sheetmetal screws (1/2" long)
Attach the sides to the intermediate posts and bottom panel of
the installed cabinet section.