Canon CR-50 - Manual (Page 54)

54
F
Adjust the gap between the feeding roller and the separation
roller to optimum width.
While one sheet remains in place between the rollers,
continuously attempt to slide the second sheet (in front of the
remaining sheet) to the right, back through the roller gap.
Slowly turn the paper thickness adjustment dial clockwise (right)
just until the second sheet stops feeding into the gap.
IMPORTANT
Turning the Adjustment Dial clockwise too much may damage the rollers.
G
Remove the sheets from the paper path and close the
Maintenance Cover.
H
Confirm that the document feeds properly.
See “Confirming Proper Document Feeding,” on p. 37.
If additional assistance is required, contact your local authorized
Canon dealer or service representative.
I
Place a marking label on the unit pointing to the adjustment
dial as illustrated below. This will serve as a reference point
for future adjustments if required.
Second sheet does not feed
into the gap.
Marking labels for thickness
adjustment dial