Canon CR-50 - Manual (Page 17)

17
Preparation Before Use
This chapter describes how to prepare the scanner to scan
documents.
Perform the following steps to set up the CR-50/80. Refer to the section
for each step for details about that step.
A
Check your operating environment. (See “Checking Your
Operating Environment,” on p. 18.)
B
Install the software. (See “Installing the Software,” on
p. 19.)
Install the Scanning Utility provided with the CR-50/80.
C
Connect the scanner to a computer. (See “Connecting
the Scanner to a Computer,” on p. 21.)
D
Turn ON the power. (See “Turning ON the Power,” on
p. 22.)
E
Automatically installing the device driver. (See p. 23.)
The device driver is installed automatically when Windows
recognizes the CR-50/80.
IMPORTANT
• To have the device drivers installed automatically when the computer
recognizes the CR-50/80, the software needs to be installed before the
CR-50/80 is connected to the computer.
• If you connect the computer and turn ON the CR-50/80 before installing the
software, the following wizard screen appears. If this happens, click
[Cancel], turn OFF the CR-50/80, and then install the software.
The following wizard screen is an example in Windows 7. When a similar
wizard screen appears in Windows XP/Vista, click [Cancel].
Setting Up the Scanner
Wizard Screen (Windows 7)