Ram Trucks 2013 Chassis Cab - User Guide - Manual (Page 124)

JACKING AND TIRE CHANGING
4500/5500 Models
•
These vehicles do not come equipped with a jack.
NOTE:
Jacking and tire changing on 4500/5500 models should be performed by an
authorized dealer, or knowledgeable service personnel with the appropriate heavy
duty equipment, like a tire service company.
Preparations For Jacking
1. Park the vehicle on a firm, level surface. Avoid ice or slippery areas.
2. Turn on the Hazard Warning flasher.
3. Set the parking brake.
4. Place the shift lever into PARK (automatic transmission) or REVERSE (manual
transmission). On 4-Wheel drive vehicles, shift the transfer case to the “4L”
position.
5. Turn OFF the ignition.
• Block both the front and rear of the
wheel diagonally opposite the jacking
position. For example, if the right front
wheel is being changed, block the left
rear wheel.
NOTE:
Passengers should not remain in the ve-
hicle when the vehicle is being jacked.
Jacking Instructions
Instructions
1. If equipped, remove the spare wheel,
jack, and tools from storage.
2. Using the wheel wrench, loosen, but do
not remove, the wheel nuts by turning
them counterclockwise one turn while
the wheel is still on the ground.
WHAT TO DO IN EMERGENCIES
122