Perfect Aire PAHP12002 - Manual (Page 15)

A. 3/4” (19.1 cm) extending into room
B. Trim
14
A
B FIG.22 FIG.23
FIG.24 FIG.25
Install Cabinet into Wood Frame:
1. Insert cabinet into the framed wall opening. The top of the cabinet should extend 3/4″ (19.1 mm) into the
room. If there is trim, the cabinet should extend 3/4″ (19.1 mm) past trim (FIG. 22).
2. Use a level to check that cabinet is level side to side (FIG. 23).
3. Check that air conditioner cabinet is tilted to the outside so that water can run to the outside. The cabinet
should slope at least half a bubble (on your level) towards the rear (FIG. 23).
4. Reuse the insulation to seal opening between cabinet and frame.
5. Use existing holes in sides and top of cabinet and seven #10 x 1″ wood screws (not provided) to attach
cabinet to frame.
6. Caulk all outside wall openings around cabinet.
Do not over tighen screws or the cabinet will distort and provide a poor air seal between cabinet and
air conditioner.
Complete Installation:
1. Insert air conditioner into cabinet (FIG . 24).
2. Insert front tabs of front panel into top of cabinet and swing front into place.
3. Attach bottom front of panel with front panel screws (FIG. 25).
4. Plug into a grounded 3 prong outlet.
5. Press RESET on the power supply cord.
Handle
NOTE: After installing, make sure the air conditioner is tilted 3-4° to the outside to allow water drainage
and perfect cooling efficiency.
the air conditioner gently. For through-the-wall installations, if needed, install molding
around the room side of cabinet.
INSTALLATION INSTRUCTIONS
Level