Perfect Aire PAHP12002 - Manual (Page 12)

FIG. 11
FIG. 8 FIG. 9 FIG. 10
FIG. 12
FIG. 13
A
B
A
B
C
A. #10 x 1/2″ pan-head Phillips screws
B. #10 x 3/4″ (or 1/2″) round-head screw
C. Window channel
A
B
A. Curtain housing
B. Foam adhesive seal
A. Window sash
B. Empty cabinet
C. Window channel
Attach foam adhesive seal:
Attach foam adhesive seal along the bottom of the curtain bottom channel (FIG. 8).
Install Cabinet into Window:
1. Center empty cabinet in window:
Check that lower rail of air conditioner cabinet is behind and against back side of window sill. Maintain a
firm hold on the air conditioner cabinet (FIG. 9). Lower window sash to hold the cabinet in place. Measure
the distance between the right side of the cabinet and the inside of the window channel (FIG. 10). Repeat
for the left side. Adjust the cabinet until the distance on each side is the same.
2. Attach the cabinet to window:
A: For wooden windows:
Use a 3/16″ drill bit to drill three starter holes 3/8” deep through the three holes in the cabinet and into the
window sill, and drill one starter hole 3/8″ deep through the hole in the middle of top rail and into the window
frame (FIG. 11). Attach cabinet to window with three #10 x 1/2″ pan-head Phillips screws and one #10 x 3/4″
or (1/2″) round-head screw (FIG. 11).
B: For Vinyl-Clad windows:
Use a 1/8″ drill bit to drill one hole through the hole in the middle of top rail and into the window frame. Attach
cabinet to window with one #10 x 3/4″ or (1/2″) round-head Phillips screw (FIG. 11). Place two safety locks
into the holes located in the bottom of the cabinet as shown (FIG. 12).
3. Check that the air conditioner cabinet is tilted back 5/16” to 3/8” so that water can run to the outside (FIG. 13).
B
A A
C
A
A. #10 x 1/4″ Pan-head
Phillips screws
B. Safety Lock
Only for vinyl-clad windows
INSTALLATION INSTRUCTIONS
Window Sash
Angle of cabinet
bracket securely seated
on edge of inner sill.
Side Louvers
Window Sill
Window
Outer Sill
Window
Inner Sill
Cabinet
Bracket
11