Perfect Aire PNC18000 - Manual (Page 12)

11
Sill
Sill
Angle
Top
View
Air Conditioner
Cabinet
Plastic
Frame
I Section
Window
Filler
Panel
Locking
Screw
Hole
Bottom
Rail Seal
3/4" (or 1/2") Long
Hex-Head Screw
1/2" Long
Screws and
Left
Right
Sill Angle
Bracket
Flat Head
Bolt
2 Each Required For
Each Support Bracket
Locknut
3
4
Assemble Window Filler Panels
2. Slide "I" section of window filler panel into side
retainer on the side of the cabinet. (See Fig. 9.)
panel frame into channel in the top angle
.)
4. Insert washer head locking screws (2) into holes
in top leg of filler panel frame. (See S
Place Cabinet in Window
1. Open window and mark center of window sill.
(See Fig. 10.)
2. Place cabinet in window with bottom sill angle
firmly seated over window sill as shown.
(See Fig. 10A.) Bring window down temporarily
behind top angle to hold cabinet in place.
Shift cabinet left or right as needed to line up
center of cabinet on center line marked on sill.
4. Fasten cabinet to window sill with 2 screws into
holes. (You may wish to pre-drill pilot holes.)
5. Add bottom rail seal over screws in window sill.
(See Fig. 11.)
Fig. 9A
Fig. 10 Fig. 10A
Plastic
Frame
Window Filler
Panel
Side Retainer
Fig. 9
Fig. 11 Fig. 12
Fig. 13
Install Support Bracket
of sill and tighten to bottom of cabinet as shown
and remove.
2. Assemble sill angle bracket to support brackets
attached) to correct hole in bottom of cabinet.
(See Fig. 14.)
1/2" Long
Screws and
Locknuts Fig. 14
5