Perfect Aire PNC18000 - Manual (Page 11)

10
1 Remove Chassis
1. Pull down front grille and remove
filter.(See Fig. 1.)
2. Lift front grille upwards and place to one side.
3. Locate and remove the four front screws.
These screws will be needed to re-install
the front panel later. (See Fig. 2.)
4. Push metal cabinet side to release plastic
tabs on each side of front panel.
(See Fig. 3.)
5. Gently lift front panel off unit.
(See Fig. 3A.)
6. Place front panel to one side.
(See Fig. 4.)
7. Remove shipping screws from top of unit and
also on the side by the base if installed.
(See Fig. 5.)
8. Hold the cabinet while pulling on the base
handle, and carefully remove the unit.
9. Add two foam inserts to holes in top of cabinet
where shipping screws were removed from.
(See Fig. 6.)
0. Your unit may come with internal packaging.
This packaging MUST be removed prior to
installing the air conditioner back into the
cabinet. (See Fig. 7.)
2 Install Top Angle and Side Bracket
Front Grille
Fig. 1 Fig. 2
Front Panel
Fig. 3
Fig. 3A
Fig. 4
Shipping
Screws
Fig. 5
Fig. 7
Shipping Packaging
Plastic tie
1
1.
2. Install top angle and side retainers to cabinet.
(See Fig. 8.)
Fig. 6
hex
16
-hea
long
d 5/
Fig. 8
Attach foam gasket to top angle above holes.
(See Fig. 6.)
Window Mounting