Perfect Aire PACSO12000 - Manual (Page 9)

on off
Timer
Temp/Timer
On/off
Temp/Timer
Fan Speed
Check
Filter
Sleep
Auto
Low
Med
High
on off
Timer
Temp/Timer
Energy
Saver
Temp/Timer
Auto
Cool
Dry
Fan
Mode
Heat
TIMER: AUTO START/
STOP FEATURE:
Press Timer
button
DO THIS:
AIR CONDITIONER FEATURES(CONTINUED)
NOTE:
CHECK FILTER FEATURE:
Press Check
Filter button
DO THIS:
This feature is a reminder to clean the Air Filter for
more efficient operation. The LED(light) will illumi-
nate after 250 hours of operation. To reset after
cleaning the filter, press the Check Filter button and
the light will go off.
NOTE:
- When the unit is on or off, first press the Timer button,
the TIMER ON indicator light illuminates. It indicates
the Auto Start program is initiated.
- When the time of TIMER ON is displayed ,press the
Timer button again, the TIMER OFF indicator light
illuminates. It indicates the Auto Stop program is
initiated.
- Press or hold the UP or DOWN button to change the
Auto time by 0.5 hour increments, up to 10 hours,then
at 1 hour increments up to 24 hours. The control will
count down the time remaining until start.
- The selected time will register in 5 seconds, and the
system will automatically revert back to display the
previous temperature setting or room temperature when
the unit is on.(when the unit is off,there is no display.)
- Turning the unit ON or OFF at any time or adjusting
the timer setting to 0.0 will cancel the Auto Start/Stop
timed program.
S II
8
on off
Timer
Temp/Timer
Energy
Saver
Temp/Timer
Auto
Cool
Dry
Fan
Mode
Heat
DISPLAYS:
Displays
O O Shows the set temperature in " C" or " F" and the
Auto-timer settings.While on Fan only mode,it shows
the room temperature.
DISPLAYS:
-Evaporator temperature sensor error-Unplug the
unit and plug it back in.If error repeats, call for
service.
NOTE: " " is displayed as shown in the left picture.
HS -Electric heating sensor error-Unplug the unit and
plug it back in.If error repeats, call for service.
Error codes:
AS-Room temperature sensor error-Unplug the unit
and plug it back in.If error repeats, call for service.
NOTE:In Fan only mode,it will display" LO" or " HI" .
S II