Perfect Aire PACSO12000 - Manual (Page 8)

on off
Timer
Temp/Timer
On/off
Temp/Timer
Fan Speed
Check
Filter
Sleep
Auto
Low
Med
High
on off
Timer
Temp/Timer
Energy
Saver
Temp/Timer
Auto
Cool
Dry
Fan
Mode
Heat
AIR CONDITIONER FEATURES(CONTINUED)
TO SELECT THE
OPERATING MODE:
Press the Mode
button.
DO THIS:
TO USE THE ENERGY
SAVER FEATURE:
Press the button
DO THIS:
SLEEP FEATURE:
Press Sleep
button
DO THIS:
7
on off
Timer
Temp/Timer
Energy
Saver
Temp/Timer
Auto
Cool
Dry
Fan
Mode
Heat
NOTE:
To choose operating mode, press the Mode button.
Each time you press the button, a mode is selected
in a sequence that goes from Auto, Cool, Dry ,Heat
and Fan.The indicator light beside will be illuminated
and remained on once the mode is selected.
NOTE:
To operate on Auto feature:
In this mode, the fan speed cannot be adjusted, it
starts automatically at a speed according to the
room temperature.
To operate on Fan Only:
Use this function only when cooling is not desired,
such as for room air circulation or to exhaust stale
air(on some models). (Remember to open the vent
during this function, but keep it closed during
cooling for maximum cooling efficiency.) You can
choose any fan speed you prefer.
During this function, the display will show the actual
room temperature, not the set temperature as in the
cooling mode.
This function is available on COOL mode.The fan
will continue to run for 3 minutes after the compressor
shuts off.The fan then cycles on for 2 minutes at 10
minute intervals until the room temperature is above
the set temperature, at which time the compressor
turns back on and Cooling Starts.
NOTE:
To operate on Dry mode:
In this mode, the air conditioner will generally
operate in the form of a dehumidifier. Since the
conditioned space is a closed or sealed area, some
degree of cooling will continue.
When you set the air conditioner in AUTO mode, it will
automatically select cooling, heating(cooling only models
without), or fan only operation depending on what
temperature you have selected and the room temperature.
The air conditioner will control room temperature
automatically round the temperature point set by you.
In Fan only mode ,the temperature is not adjusted.
In this mode the selected temperature will increase
O O (cooling) or decrease(heating) by 2 F/1(or 2) C
30 minutes after the mode is selected. The temperature
will then increase(cooling) or decrease(heating) by
O O another 2 F/1(or 2) C after an additional 30 minutes.
This new temperature will be maintained for 6 hours
before it returns to the originally selected temperature.
This ends the Sleep mode and the unit will continue to
operate as originally programmed. The Sleep mode
program can be cancelled at any time during operation
by again pressing the Sleep button.
S II
S II