Perfect Aire PNC12000 - Manual (Page 8)

7
Low
Fan Mode
Energy
Saver
Follow
Me
Ion
TO SELECT THE
OPERATING MODE:
Press the
“Mode” button.
DO THIS:
TO USE THE ENERGY
SAVER FEATURE:
Press the
“Energy Saver”
button
DO THIS:
SLEEP FEATURE:
Press “Sleep”
button
DO THIS:
In this mode the selected temperature will increase by
2 O F/1(or 2) O C 30 minutes after the mode is selected. The
temperature will then increase by another 2 O F/1(or 2) O C
after an additional 30 minutes. This new temperature
will be maintained for 6 hours before it returns to the
originally selected temperature. This ends the Sleep
mode and the unit will continue to operate as originally
programmed. The Sleep mode program can be
cancelled at any time during operation by again
pressing the “Sleep” button.
NOTE: SLEEP button
To choose operating mode, press the “Mode” button.
Each time you press the button, a mode is selected
in a sequence that goes from “Auto,” “Cool,” “Dry,”
and “Fan.” The indicator light will be illuminated and
remain on once the mode is selected. The unit will
automatically initiate the Energy Saver function
under “Cool,” “Dry,” and “Auto” (only Auto-Cooling
and Auto-Fan) modes.
NOTE: MODE button
To operate on “Auto” feature:
To operate on “Fan” only (not available on all models):
Use this function only when cooling is not desired,
such as for room air circulation or to exhaust stale
air. (Remember to open the vent during this function,
but keep it closed during cooling for maximum cooling
efficiency.) You can choose any fan speed you prefer.
During this function, the display will show the actual
room temperature, not the set temperature as in the
cooling mode.
NOTE: ENERGY SAVER button
To operate on “Dry” mode:
In this mode, the air conditioner will reduce air humidity.
If the space is a closed or sealed area, some degree of
cooling will continue.
When you set the air conditioner in “Auto” mode, it will
automatically select cooling, heating (on models with heating
capabilities), or fan only operation depending on what
temperature you have selected and the room temperature.
The air conditioner will control room temperature
automatically around the temperature you set.
In this mode, the fan speed cannot be adjusted.
It starts automatically at a speed according to the
room temperature. If the room does not get too warm,
it will stay at “Low” speed.
This function is available on “Cool,” “Dry,” and “Auto”
(only Auto-Cooling and Auto-Fan) modes. In this
mode,the fan will continue to run for 3 minutes after the
compressor shuts off.The fan then cycles on for 2
minutes,at 10 minute intervals, until the room
temperature is above the set temperature, at which
time the compressor turns back on and cooling starts.
AIR CONDITIONER FEATURES (CONTINUED)
Low
Auto
Med
High
Auto
Cool
Dry
Fan
Fan Mode
Ion
Auto
TEMP/TIMER
Auto
On
Off
Sleep
Timer
Check
Filter