Perfect Aire PNC12000 - Manual (Page 12)

11
INSTALLATION INSTRUCTIONS (CONTINUED)
PREPARE THE WINDOW 1
3/4 (or 1/2 )
Screws
(7)
Lock Frame
(2)
Sash Lock
(1)
Mounting Hardware
Window sash
seal foam
(1)
PREPARE AIR CONDITIONER 2
C: Align the hole in the top rail with those in the
top of the unit as shown in Fig.B
D: Secure the top rail to the unit with the 3/8"
screws as shown in Fig.C.
NOTE: For safety reasons, all four(4) screws
MUST be securely fastened.
INSTALL THE ACCORDION PANELS 3
NOTE: Top rail and sliding panels on each side
are offset to provide the proper pitch of 5/16" to
the rear. This is necessary for proper condensed
water utilization and drainage. If you are not
using the side panels for any reason, this pitch to
the rear must be maintained.
A.Place unit on floor, a bench
or a table. Hold the
accordion panel in one
hand and gently pull back
the center to fill the
open end. See Fig.1.
Fig.1
Lower sash must open sufficiently to allow a clear
vertical opening (H) of the following size. (See
Table 1 below.) Side louvers and the rear of the AC
must have clear air space to allow enough airflow
through the condenser for heat removal. The rear
of the unit must be outdoors, not inside a building
or garage.
A: Remove the air conditioner from the carton and
place on a flat surface.
NOTE: The top rail hardware and Fig. A, Fig. B,
and Fig. C are not applicable to the units
10,000 BTU/h or greater. For models less than
10,000 BTU/h, the top rail must be assembled.
B: Remove top rail from the rear of the packaging
material as shown in Fig. A.
Packaging
Fig. A
Top Rail
Fig.B
Fig.C
Top Rail Hardware
3/8" Screws
(4)
Top Rail
(1)
or or
Model
Size (H)
5000~8000 Btu/h 10000~12000 Btu/h
14” (356 mm) 15-1/2” (394 mm)
Table 1