Philips MC165C-37 - Manual (Page 8)

GENERAL INFORMATION REMOTE CONTROL POWER SUPPLY
CQ
Supplied accessories
- 2 speakers
- 2 speaker cables
- Remote control
- 2 batteries for the remote control
- AM/MW frame antenna
- FM wire antenna
- AC power cord
Safety information
Place the unit on a solid surface. Make sure there is
sufficient space around the unit to prevent overheating.
Active mobile phones near to the CD player may cause
malfunctions.
Maintenance
Do not expose the unit, batteries
or CDs to humidity, rain, sand or
excessive heat (caused by heating
equipment or direct sunlight).
You can clean the unit with a
soft, slightly dampened lint-free
cloth. Do not use any cleaning
agents as they may have a
corrosive effect.
Batteries for the remote control
• Open the battery compartment of the remote control and
insert 2 batteries, type R03, UM-4 or AAA (preferably
alkaline).
Remove batteries if they are dead or the unit is not going
to be used for a long time.
Batteries contain chemical substances, so they
should be disposed of properly.
Speaker connections
The speaker terminals are click-fit connectors. Use them as
shown below.
• Connect the unmarked wire to the red terminal and the
marked (black) wire to the black terminal.
Mains
The type plate is located on the back of the unit
1 Check whether the mains voltage as shown on the type
plate corresponds to your local mains voltage. If it does
not, consult your dealer or service organisation.
2 Connect the mains cable to tbe AC MAINS inlet and the
wall socket. This switches on the mains supply.
To disconnect the unit from the mains completely, remove
the mains plug from the wall socket.
To avoid overheating of the unit a safety circuit has
been built in. Therefore your unit may disconnect
under extreme conditions. If this happens, switch
the unit off and let it cool down before reusing it.