Cisco 8961 - Manual (Page 8)

E-8
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 8.6 (SIP)
Appendix E Installing the Wall Mount for the Cisco Unified IP Phone
Installing a Wall Mount for a Phone with a Key Expansion Module
Installing a Wall Mount for a Phone with a Key Expansion
Module
This section describes how to install a wall mount for the Cisco Unified IP Phone 8961, 9951, and 9971
connected with the Key Expansion Module.
Figure E-7 Wall Mount Kit for Phone with Key Expansion Module
The package includes these items:
• 1 phone bracket
•
1 wall bracket
•
4 10-12x1 inch Phillips-head screws with 4 anchors
•
1 sheet metal screw
•
3 4-40x1/4 inch machine screws
•
1 six-inch Ethernet cable
• 1 key if the bracket includes the optional lock
Before You Begin
You need these tools to install the bracket:
•
#1 and #2 Phillips-head screwdrivers
• Level
You must also install an Ethernet jack for the telephone in the desired location if an Ethernet jack does
not currently exist. This jack must be wired appropriately for an Ethernet connection. You cannot use a
regular telephone jack. For more information about phone installation requirements and warnings, see
the
Setting Up the Cisco Unified IP Phone chapter.
screw
Machine
screws
(3)
Ethernet
cable
Lock-down
key
206769
(4) (4)