Casio IT-2000 - Manual (Page 25)

25
Error Code
categ Detai
Error Message Description Remedy
0x04 0x00 ReadOnlyFileAccessError Write is specified to read-only-file. Change the file attribution for
write.
0x05 0x00 CommunicationError Communication error. See note 1.
0x05 0x03 SpawnError Spawn error. See note 1.
0x05 0x04 CommandTimoutError Command timeout error. See note 1.
0x05 0x05 ErrorOpeningErrorLogFile Fail to open log file. Check if the path name of log file
is correct.
0x05 0x06 OptionError Option error. Check if the selection of operation
is correct.
0x05 0x07 StartupError Startup error. Check if other application is using
the COM port.
0x05 0x08 OpenError Open error. See note 1.
0x05 0x09 ListenError Listen error. See note 1.
0x05 0x0A AcceptError Accept error. See note 1.
0x05 0x0B NotEnoughMemoryToExecuteProcess Memory is not enough. Close other applications first.
0x05 0x0C ArgumentListTooLargeForTheProcess Process is too long. See note 1.
0x05 0x0D InvalidModeForTheProcess Child-process ends illegally. Check the operation method.
0x05 0x0E ProcessTerminatedNormally Child-process ends normally. Normal end.
Er
ror
0x05 0x0F NoiseError Communication noise error. See note 1.
Table 4.2 Error codes and error messages
Note:
1. First make sure the connection of each option is complete and each component is
powered properly. Next, restart the system and execute the process again. If the same error
occurs again, reduce the baud rate before retrying. If normal operation cannot be achieved even
after making the above adjustments, contact your nearest support/technical center.
2. The file could not be properly accessed. Check if the file can be properly accessed or if the
disk is full.