Casio EX-S100 - Manual (Page 199)

APPENDIX
199
Position the camera so sunlight does not shine
directly into the lens.
This camera cannot display non-DCF images
recorded onto a memory card using another digital
camera.
Remove the battery from the camera, reinsert it,
and then try again.
After the computer stops accessing camera file
memory, press the [USB] button on the USB
cradle. Check to make sure that the [USB] lamp
on the USB cradle is off, and then remove the
camera from the USB cradle.
1) Check the connection between the camera and
USB cradle.
2) Check all connections.
3) Install the USB driver on your computer (page
159).
4) Press the [USB] button on the USB cradle.
Color of the playback
image is different from the
image on the monitor
screen during recording.
Images are not displayed.
All buttons and switches
are disabled.
Monitor screen is off.
Cannot transfer files over a
USB connection.
Sunlight or light from another source is shining
directly into the lens during recording.
A memory card with non-DCF images recorded
with another camera is loaded in the camera.
Circuit problem caused by electrostatic charge,
impact, etc. while the camera was connected to
another device.
USB communication is in progress.
1) Camera is not set securely on the USB cradle.
2) USB cable is not connected securely.
3) USB driver is not installed.
4) Camera is turned off.
Other
Symptom Possible Cause Action
Playback