OmniSistem PR Pilot 1200 - Manual (Page 14)

Pilot 1200 manual.doc 14/20
PROBLEM POSSIBLE CAUSE ACTION
The projector doesn’ t switch
on
-The power supply is not
present
-The lamp doesn’
t work
Check the fuse on the power
socket.
Replace the lamp.
The lamp comes on but the
projector doesn’
t respond to
the controller
-Wrong DMX configuration
and/or start address
- Defective DMX cable Make sure that the projector is
correctly configurated.
Replace or repair the DMX cable.
The projector only functions
intermittently -The fan has failed Make sure the fan is working and
not dirty.
Defective projection -The lens is broken
-Dust or grease on lenses Check the lenses are not broken.
Remove dust or grease from the
lenses.
The projected image
appears to have a halo -Installation of the lamp is not
correct
-Dust or grease contamination
on the optics. Make sure the lamp is installed
correctly.
Carefully clean the optical group
lenses and the projector
components.
The beam appears dim -Dust or grease contamination
on the optics.
-The lamp is at the end of its
life Check the optics is clean.
Replace with a new lamp of the
specified type and rating.
LIGHT OUTPUT
TROUBLESHOOTING