OmniSistem Spark 7 Zoom - Manual (Page 8)

The unit can be placed directly on the stage floor or rigged in any orientation on a truss without altering its
operation characteristics (see the drawing).
The fixture base enables mounting in two
ways.
For overhead use (mounting height
>100cm), always install an appropriate
safety bond.
Please note: for overhead rigging in
public or industrial areas, a series of
safety instructions in this manual need
to be followed. The operator must inform
themselves on the current safety
instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Install the safety bond by inserting the quick link in the hole on the bottom of the base. Pull the safety bond over
the trussing system. Insert the end in the quick link and tighten the fixation screw.
The maximum drop distance must never exceed 20cm.
A safety bond which already holds the strain of a fall or which is defective must not be used again.
8 of 25