OmniSistem Spark 7 Zoom - Manual (Page 18)

TILT Reverse
With this function you can reverse the tilt movement.
PAN Degree
With this function you can select the pan degree.
1. Select “PAN degree” by pressing Up or Down.
2. Press the Enter button, the display shows “540”.
3. Press Up or Down to select the desired degree between “540” and “630”.
4. Press the Enter button to confirm.
Automatic PAN/TILT calibration
With the function "Encoders" you can calibrate the pan/tilt movement to the correct starting position.
Adjust PAN/TILT speed
With this function you can define the pan/tilt speed. You can select one of two different modes.
UI Set
Mic Sensitivity
With this function, you can select the desired microphone sensitivity between 0% and 99 %.
1. Select “Mic Sens” by pressing Up or Down.
2. Press the Enter button.
3. Press Up or Down to select the desired sensitivity.
4. Press the Enter button to confirm.
No DMX Status
With the function "No Signal", you can set different modes if there is no DMX signal.
1. Select "Close, Hold, Auto or Music" by pressing Up or Down.
2. Press Up or Down to select between "Close", "Hold", "Auto" or "Music".
3. Press the Enter button to confirm.
Select Temperature Designation
With this function you can select the temperature designation.
1. Select “Temperature C/F” by pressing Up or Down.
2. Press Up or Down to select the desired degree between “Celsius” and “Fahrenheit”.
3. Press the Enter button to confirm.
Hibernation ­ Power Standby Mode
With this function you can put the device in the power standby mode. This function will be automatically activated
after a predefined period of time of no DMX activity. In standby mode the lamp/LEDs and all motors will power
down if no DMX signal is sent to the fixture for a period of e. g. 15 minutes (can be user defined). The fixture will
automatically reset and return to normal operation once a DMX signal is sent.
Backlight
With this function you can shut off the display after 2 to 60 minutes.
Flip Display
With this function you can flip the display by 180° for a better view when the fixture is installed upside down.
Shortcut: Press “up” and “down” for three seconds to flip the display directly.
Brand Show
With this function you can show or hide the brand name on the display during menu
operation, but still show it after reset.
Key Lock
With this function you can lock the keys of the Control Board to e.g. prevent menu tampering. If this function is
18 of 25