OmniSistem OnyxPro 40 - Manual (Page 17)

conventional devices.
If DMX splitters are used and RDM control is to be used, these splitters must support RDM.
The number and type of RDM parameters depend on the (optional) RDM controller being used.
In general, the device supports the following commands via RDM:
RDM Parameter ID's (Slot 21­22) Value
Category _Network Management
DISC_UNIQUE_BRANCH 0x0001
DISC_MUTE 0x0002
DISC_UN_MUTE 0x0003
Category ­RDM Information
SUPPORTED_PARAMETERS 0x0050
PARAMETER_DESCRIPTION 0x0051
Category _Product Information
DEVICE_INFO 0x0060
DEVICE_MODEL_DESCRIPTION 0x0080
MANUFACTURER_LABEL 0x0081
DEVICE_LABEL 0x0082
FACTORY_DEFAULTS 0x0090
SOFTWARE_VERSION_LABEL 0x00C0
Category ­DMX512 Setup
DMX_PERSONALITY 0x00E0
DMX_PERSONALITY_DESCRIPTION 0x00E1
DMX_START_ADDRESS 0x00F0
SLOT_INFO 0x0120
SLOT_DESCRIPTION 0x0121
Category _Sensors
SENSOR_DEFINITION 0x0200
SENSOR_VALUE 0x0201
Category _Power/Lamp Settings 0x04xx
DEVICE_HOURS 0x0400
Category ­Display Settings
DISPLAY_INVERT 0x0500
17 of 20