Char-Broil SILVER SMOKER 3201560 - Manual (Page 5)

6
5
Insert a
cotter pin into the hole at one end of the axle and bend the ends of the pin back so that it cannot be removed. Slide a
wheel onto the axle. Slide the axle through the holes at the ends of the short legs. Slide remaining wheel onto axle and secure
with remaining
cotter pin.
Axle
NOTE: Smoker chamber door not pictured
for clarity.
Stand the leg assembly on end, wheels
down. Stand the smoker chamber on its
solid end, open end up. Place leg assembly
against chamber, aligning holes in legs with
holes in chamber. Attach legs to chamber
using four
1/4-20x2” screws and 1/4-20
flange nuts. Insert screws from outside,
flange nuts inside chamber.
FULLY TIGHTEN ALL SCREWS AND
NUTS AT THIS TIME.
Smoker chamber
Cotter pin
Cotter pin
Wheels down
Open end up