NORAC UC5-BC-HG07 - Manual (Page 24)

21
8.3 Input Module
1. Install the input module (E03) on the boom near the sprayer valve block. Secure it to the
bracket beside the valve block (Figure 19).
2. Connect the free end of the CANbus cable (C05) from the valve module to the input
module. Connect the second cable C05 to the other CANbus connector and route to the
8-way coupler.
3. Insert the 12-pin plug (P02) into the OEM 3 connector on the end of the input module.
Part P02 is not included in the factory installed kit.
4. Connect the 12-pin connectors on the interface cable (C20) to the Thru 2 connector and
the Thru 1 connector on the sides of the input module.
Figure 20: Input Module Connections
5. Connect the 12-pin plug on C20 to the 12-pin receptacle on C10.
6. Connect the 12-pin receptacle on C20 to the Hagie interface connection.