beautypg.com

9 connecting the sensors to the canbus, 9connecting the sensors to the canbus – NORAC UC5-BC-HG04 User Manual

Page 27

background image



24

9

Connecting the Sensors to the CANbus

1. Connect the main lift sensor to the 8-way coupler using cable C04 and a 2-way coupler

(E12). Cable C04 and item E12 may not be needed if the 8-way coupler is mounted close
enough to the main lift sensor.

2. Connect the sensor on the linear roll cylinder to the 8-way coupler using cable C04 and a

2-way coupler (E12).

3. Attach a 3-way coupler (E10) to the boom at the inner sensor brackets. Connect two

cables (C05) to the 8-way coupler and route along the booms to the inner wing sensors.
Plug the sensor and the CANbus cable into the 3-way coupler.

4. Connect cable C05 to the remaining connector on the 3-way coupler and route along the

boom to the outer wing sensors.

Figure 23: UC5 Module Locations and Cable Connections

5. At the sensor brackets, attach a 2-way coupler with terminator (E20) to the sprayer boom.

The 2-way coupler with terminator is the white two way coupler. Plug the sensor and the
CANbus cable into the 2-way coupler.

Ensure that all unused connectors are plugged with the plugs provided.