NORAC UC5-BC-HG04 - Manual (Page 18)

15
Figure 12 - Linear Roll Cylinder Sensor and Target Alignment
6. Install the cylinder onto the sprayer with the damper end (end with no hoses) at the top.
When installing the cylinder use the correct spacers, as shown in Figure 13.
7. Torque the 1” mounting bolt to 500 ft-lbs.
The figure below shows a top view
of the linear roll cylinder. Notice
how the bottom target (red) is not
aligned with the sensor mount and
spring target.
The figure to the side is a side view
of the assembled linear roll cylinder.