NORAC UC5-BC-HG04 - Manual (Page 23)

20
3. Disconnect the CANbus interface connectors and insert the NORAC CANbus interface
cable (C20) between the two connectors.
4. Connect the 6 pin connector on cable C20 to the control module with the highest serial
number. This connection must go into the end of the control module with only one
connector.
5. Securely fasten the control module into the access panel area, using screws, cable ties or
optional brackets.
6. Connect the cable that was routed out of the cab, into one of the remaining 6 pin
connectors on the control module. This connection must be on the end of the module
with two connectors.
7. Connect cable C02 to the last connector on the control module.
8. Route cable C02 to the three way coupler (E10) connected to the chassis roll sensor.