NORAC UC4+BC+MS - Manual (Page 13)

10
4.2.1 Wing Sensor Installation
1. Assemble the breakaway sensor
mounting brackets (B11) as show in
Figure 9 and Figure 10.
Figure 9: Breakaway Sensor Bracket
Figure 10: Breakaway Bracket
Assembly
2. Grease the bottom edge of the collar
and the angled tube of the base.
3. Mount the sensor bracket onto the
boom.
4. Sensor cables should run through the
mounting bracket tube and then behind
the member the bracket is mounted
onto. Cable-tie the connector in place.
4.2.2 Main Lift Sensor Installation
1. Assemble the main lift sensor bracket
(B11) as shown in Figure 11.
Figure 11: Main Lift Sensor Bracket
2. The bracket can then be mounted to
the lowest frame member on the center
section of the sprayer (Figure 12).
Figure 12: Main Lift Sensor Bracket
Mounting Position
3. Mount the sensor onto the sensor
mounting collar.
Bracket Tube
Sensor
Mounting Tab
Sensor Mounting
Collar
Bracket Base